Switch Mode Power Supply (SMPS)

SMPS consists of high frequency switch which is actually transistor with frequency range 50 khz to 1 mhz.

The switch is used to control & stabilize the load current on & off.

It converts AC to DC.

Similar size, great power conversion, reduse over all power loss & generates low heat.

Disadvantage.
It generates more noise & more complex.

Comments

Tweezers

This tool is used tp piking up very small objects like small screws that are inconvenient to pick with human hand.

Asyncronous Communication

Asynchronous &is any data transmission that does not link the two devices with a common data clock. A Signal called a start bit is sent at the beginning of each segment, & a signal called a stop bit is sent at the end, these let the receiving device note the baundries(beginning & end) of a transmission packet. Early PC modems were almost Asynchronous devices operating at speeds of no more than 18,000 bps.

Diference between laptop & desktop computer

Most laptop processors are soldered directly in the motherboard, which means they cannot be removed. If there is some error in laptop processor, the entire motherboard needs to be replaced. Laptops processors can be slowed down when they are not running to their full capacity. The processor uses a technique called processor trotling that allows the operating system to put the processor in active sleep mode or shutdown mode. Laptop processors run at reduced clock rate than desktop processors. This helps them to produce less heat when running at full capacity. Laptop processors consume less power which though make them a slow performer but it greatly helps them to save battery life.

WorkStation Care

Search This Blog